Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2017 >> Envision Base >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> Dismounting/Mounting Procedures >> Tire Pressure Sensor >> Sensor Removal

Sensor Removal

  1. Remove the TORX screw (3) from the tire pressure sensor (2) and pull it straight off the tire pressure valve stem (1) (see Fig 1).
  2. Remove the tire pressure valve stem by pulling it through the rim.
  3. Follow Snap-in Style Sensor Installation  below, to replace the sensor.
Fig 1: Exploded View Of Snap-In Style Tire Pressure Sensor
G00473526Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals