Removal Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
Refer to Gasoline/Gasoline Vapors Warning .
WARNING:
Refer to Safety Goggles and Fuel Warning .
CAUTION:
When working on the fuel rail and fuel injectors, always maintain a clean work surface. Failure to maintain a clean work surface can result in contaminant on the injector seals and cause leaks.
- Remove Fuel Injection Fuel Rail Assembly. Refer to Fuel Injection Fuel Rail Assembly Replacement
- Remove the 8 plate bolts (1) and remove the EN-51146-1-2 plate (2), counterhold with a wrench (4) at the EN-51146-1-1 supports (3).
- Remove the EN-51146-1-1 supports (3).
- Disconnect the fuel injector electrical connector (3).
- Remove Fuel Injector (2) @ Fuel Injection Fuel Rail (1)
NOTE:
The EN-51146-2-5 calibrations tools must be installed.
NOTE:
Remove only the EN-51146-1-1 supports (3) of the fuel injector or fuel injectors, which will be replaced. The EN-51146-1-1 supports must remain at the injectors, which will be re-used.