Camshaft Position Sensor Replacement - Intake

WARNING: This page is about a different variant/trim than selected.

Fig 1: Camshaft Position Sensor - Intake

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement
1	Camshaft Position Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Sensor Procedure Disconnect the electrical connector. Install a NEW O-ring seal.

Callout

Component Name

Preliminary Procedure
Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement

Camshaft Position Sensor Bolt

CAUTION:

Tighten
10 N.m (89 lb in)

Camshaft Position Sensor

Procedure