Windshield Washer Solvent Container Replacement
WARNING: This page is about a different car, the 2015 Buick LaCrosse. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS COMPANY
| Callout |
Component Name |
|
Preliminary Procedures
- Remove the windshield washer solvent container fill tube. Refer to Windshield Washer Solvent Container Filler Tube Replacement .
- Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement
.
- Disconnect the windshield washer pump and level sensor electrical connectors.
- Disconnect the electrical harness from the washer container.
- Disconnect the windshield washer pump hose from the pump and the washer container.
|
| 1 |
Windshield Washer Container Nut (Qty: 3)
Tighten
10 N.m (89 lb in) |
| 2 |
Windshield Washer Solvent Container Assembly Procedure
- Lift the windshield washer container off the three studs securing the container to the vehicle.
- Drain the windshield washer solvent from the container into a suitable clean drain pan.
- Transfer parts as needed.
|