Installation Procedure
WARNING: This page is about a different car, the 2016 Chevrolet Malibu Limited. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wheel speed sensor to the rear suspension knuckle.
- Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).CAUTION: Refer to Fastener Caution .
- Install the wheel speed sensor harness clips (1) to the rear suspension bracket.
- Install the wheel speed sensor harness clips (1) to the wheelhouse panel.
- Connect the wheel speed sensor harness electrical connector (2) and install the connector retainer to the bracket on the wheelhouse panel.
- Install the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
- Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Perform the Diagnostic System Check - Vehicle .