Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2016 >> Cascada Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.6L (LWC) - Repair Instructions >> Repair Instructions >> Fuel Feed Pipe Replacement - Underbody >> Installation Procedure

Installation Procedure

  1. Remove the CH-807  plugs from fuel feed tank pipe and fuel feed pipe.
    2. Fig 1: Fuel Tank Feed Pipe, Connector, Bracket Clip & Fuel Pressure Wiring Harness Plug
    GM2834311Courtesy of GENERAL MOTORS COMPANY
  2. Install and position the fuel feed pipe-underbody (3).
  3. Connect the fuel tank feed pipe connector (1) to the fuel feed pipe (3). Refer to Plastic Collar Quick Connect Fitting Service .
  4. Connect the fuel pressure sensor wiring harness plug (2).
    5. Fig 2: Fuel Feed Pipe And Clips
    GM2191622Courtesy of GENERAL MOTORS COMPANY
  5. Close the 4 fuel pipe clips (2).
    6. Fig 3: Fuel Feed Pipe-Underbody At Lower Bulkhead Clip
    GM4230996Courtesy of GENERAL MOTORS COMPANY
  6. Install the fuel feed pipe-underbody (1) to the lower bulkhead clip (2).
  7. Close the lower bulkhead clip (2).
  8. Drivetrain and Front Suspension Frame Replacement - Remove
    9. Fig 4: Fuel Feed Front Pipe At Fuel Feed Pipe-Underbody
    GM4230995Courtesy of GENERAL MOTORS COMPANY
  9. Install the fuel feed pipe-underbody (1) to the upper bulkhead clip.
  10. Close the upper bulk head clip (3).
  11. Connect the fuel feed front pipe (2) to the fuel feed pipe-underbody (1). Refer to Metal Collar Quick Connect Fitting Service .
  12. Engine Sight Shield Replacement - Install
  13. Battery Negative Cable Disconnection and Connection - Connect
scientia non olet · About Mike's Workshop Manuals