Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2013 >> Verano Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAF/IAT Sensor
    GM1656943Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the MAF/IAT sensor screws and tighten to 0.6 N.m (5 lb in).
    3. Fig 2: View Of Engine Harness Electrical Connector To MAF/IAT Sensor
    GM1647998Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine harness electrical connector to the MAF/IAT sensor.
scientia non olet · About Mike's Workshop Manuals