Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2013 >> Verano Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Fuel Pump Module Replacement (NT7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing only the fuel pump module, transfer the fuel level sensor. Refer to Fuel Level Sensor Replacement (NU6)  or Fuel Level Sensor Replacement (NT7) .
    2. Fig 1: Remove/Install Fuel Pump And O-Ring
    GM2292262Courtesy of GENERAL MOTORS CORP.
  2. Install the fuel pump (1) and use a NEW O-ring (2).
  3. Connect the electrical connector.
    4. Fig 2: Cam Lock Ring
    GM2292260Courtesy of GENERAL MOTORS CORP.
  4. Using the CH-48482:  wrench, install the cam lock ring (1) by turning clockwise.
  5. Install the fuel tank. Refer to Fuel Tank Replacement .
    6. Fig 3: Electrical Connector And Plastic Connector
    GM2292257Courtesy of GENERAL MOTORS CORP.
  6. Connect the fuel pump electrical connector (1) and the plastic connector (2). Refer to Plastic Collar Quick Connect Fitting Service .
scientia non olet · About Mike's Workshop Manuals