Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2013 >> Verano Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Engine Controls And Fuel - 2.0L - Repair Instructions) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: MAP Sensor
    GM1828338Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the O-ring seal with clean engine oil.
  2. Install the MAP sensor to the intake manifold.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the MAP sensor bolts and tighten to 10 N.m (89 lb in).
    4. Fig 2: MAP Sensor Connector
    GM1825525Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (2) to the MAP sensor.
scientia non olet · About Mike's Workshop Manuals