Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2013 >> Verano Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Continuously Variable Transmission (CVT)) >> Start Clutch Pressure Control Calibration Procedures >> Start Clutch Pressure Control Calibration Procedure mode

Start Clutch Pressure Control Calibration Procedure mode

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the HDS to the DLC (A) located under the driver's side of the dashboard.
    Fig 1: Identifying DLC
    G06430137Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Turn the ignition switch to ON (II).
  3. Make sure the HDS communicates with the PCM, and go to the A/T Data List. If it does not, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
  4. Follow the HDS screen prompts in the Start Clutch Feedback Learn (see the HDS Operator's manual).
  5. Test-drive the vehicle for several minutes, make sure the engine does not stall or flare when starting off, and verify that a problem does not occur on the start clutch pressure control system.
scientia non olet · About Mike's Workshop Manuals