Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2013 >> Regal GS, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Object Detection System - Park Assist System >> Repair Instructions >> Front Parking Assist Alarm Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Rear Object Sensor Housing
    GM1699865Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure the silicone decoupling ring is installed on the sensor to avoid sensor failure.

  1. Insert the sensor into the housing.
  2. Connect the electrical connector to the front object sensor.
  3. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement .
scientia non olet · About Mike's Workshop Manuals