Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2013 >> Regal GS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Hybrid/EV Control System) >> Diagnostic Information and Procedures >> DTC P0A8F >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, measure and record the battery voltage at the C1 12V battery terminals. The battery voltage should stabilize between 12.4 and 12.8 V within a few minutes of turning the ignition OFF.
  2. Ignition ON, observe the scan tool Ignition 1 Signal parameter in the 14V Power Module data list. The parameter should be within 4.5 volts of the Low Voltage Circuit Voltage measured at the C1 12V battery.
    • If the voltage is not within the specified range, check the ignition circuit to the K59 starter generator control module for high resistance.
scientia non olet · About Mike's Workshop Manuals