Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2013 >> Encore Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Replacement (LE2-AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Chevrolet Trax and 2016 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection (without KL9) Battery Negative Cable Disconnection and Connection (with KL9) 
  2. Raise and support the vehicle. Lifting and Jacking the Vehicle
  3. Transfer Case Replacement - Remove
    4. Fig 1: Engine Coolant Heater Cord
    GM4111076Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the electrical connector. (1)
  5. { If equipped }Engine Coolant Heater Cord (2) - Disconnect
  6. Starter Solenoid Cable Nut (3) - Remove
  7. Battery Positive Cable (4) - Remove
    8. Fig 2: Starter
    GM4111083Courtesy of GENERAL MOTORS COMPANY
  8. Starter Mounting Nut (1) - Remove
  9. Starter Mounting Bolt (2) - Remove
  10. Starter (3) - Remove
scientia non olet · About Mike's Workshop Manuals