Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2013 >> Encore Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Power Door Lock System And Release Systems) >> Repair Instructions >> Front Side Door Outside Handle Rod Replacement

Front Side Door Outside Handle Rod Replacement

WARNING: This page is about a different car, the 2016 Chevrolet Trax and 2016 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Side Door Outside Handle Rod
GM2770796Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the front side door trim. Refer to Front Side Door Trim Replacement (Encore)Front Side Door Trim Replacement (Trax) .
1 Front Side Door Outside Handle Rod Clip

Procedure

  1. Place the window in the full up position.
  2. Remove the water deflector.
  3. Open the handle rod by releasing the clip at the end of the handle rod.
2 Front Side Door Outside Handle Rod

Procedure

  1. Lift and turn handle rod until it releases the handle bracket.
  2. In order to prevent outside handle lever pre-load, lock, outside handle, handle bracket and cover/cap shall be fully secured to the door prior to securing integral lock clip to outside handle rod. Integral lock clip shall be in the full up position while securing to outside handle rod. Refer to Front Side Door Outside Handle Rod Adjustment .
NOTE:

Inspect the door lock system for proper operation before installing the door trim.