Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2013 >> Encore Base, AWD >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Catalytic Converter Heat Shield Replacement (2HO) >> Installation Procedure

Installation Procedure

    Fig 1: Exhaust Manifold Heat Shield
    GM2027674Courtesy of GENERAL MOTORS COMPANY
  1. Install the exhaust manifold heat shield (3).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the 2 exhaust manifold heat shield fasteners (4) and tighten to 8 N.m (71 lb in).
  3. Install the wiring harness bracket (1) and the wiring harness bracket fastener (2) and tighten to 15 N.m (11 lb ft).
  4. Install the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement .
  5. Connect the air conditioning compressor hose to the air conditioning compressor assembly. Refer to Air Conditioning Compressor Hose Replacement (LUJ, LUV) or Air Conditioning Compressor Hose Replacement (2H0) .
  6. Connect the air conditioning condenser hose to the compressor assembly. Refer to Air Conditioning Condenser Hose Replacement (LUJ, LUV) or Air Conditioning Condenser Hose Replacement (2H0) .
  7. Connect the heated oxygen sensor wiring harness plug.
  8. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals