Circuit/System Verification
- Verify the coolant in the radiator surge tank is at the correct level and there are no engine coolant leaks. Loss of Coolant , and Cooling System Draining and Filling
- If the coolant level is not correct
Repair as necessary.
- If the coolant level is correct
- If the coolant level is not correct
- Ignition ON.
- Verify the parameters listed below do not display Malfunction when commanding the Engine Coolant Thermostat Heater ON and OFF with a scan tool.
- Engine Coolant Thermostat Heater Control Circuit Low Voltage Test Status
- Engine Coolant Thermostat Heater Control Circuit Open Test Status
- Engine Coolant Thermostat Heater Control Circuit High Voltage Test Status
- If Malfunction is displayed
Refer to Circuit/System Testing below.
- If Malfunction is not displayed
- If Malfunction is displayed
- Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
- Verify the DTC does not set.
- If any DTC sets
Refer to Circuit/System Testing below.
- If the DTC does not set
- If any DTC sets
- All OK.