Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2012 >> Regal Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Hybrid/EV Control System) >> Diagnostic Information and Procedures >> DTC P0A2F >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2013 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the cooling system for the correct amount of coolant. Refer to Cooling System Draining and Filling (Static Fill) , Cooling System Draining and Filling (GE 47716) .
  2. Verify that DTC P0A2C is not set.
  3. Ignition ON, observe the scan tool motor temperature parameter. The reading should be less than 165°C (329°F). If greater than the specified value, replace the starter generator assembly.
scientia non olet · About Mike's Workshop Manuals