Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2012 >> Regal Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 355 (Antilock Brake System) >> Diagnostic Information and Procedures >> DTC C0110 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2013 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the K17 Electronic Brake Control Module. It may take up to 2 minutes for all vehicle systems to power down.
  2. Test for less than 10 Ω between the ground circuit terminals listed below and ground:
    • Terminal 13
    • Terminal 38
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open high/resistance in the circuit.
      • If less than 2 Ω, repair open high/resistance in the ground connection.
    • If less than 10 Ω 
  3. Ignition ON.
  4. Verify that a test lamp illuminates between the B+ circuit terminal 1 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the B+ circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, verify the fuse is not open and there is voltage at the fuse.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Ignition OFF.
    2. Test for infinite resistance between the B+ circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K17 Electronic Brake Control Module.
    • If the test lamp illuminates 
  5. Replace the K17 Electronic Brake Control Module with Brake Pressure Modulator.
scientia non olet · About Mike's Workshop Manuals