Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2012 >> Regal Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 321 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Roof Side Rail Module Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2013 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to SIR Inflator Module Handling and Storage Warning .

WARNING:

Refer to SIR Warning .

NOTE:

The inflatable restraint roof side rail module cannot be removed without destroying it must be replaced.

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the headlining trim panel. Refer to Headlining Trim Panel Replacement (With Sunroof) , Headlining Trim Panel Replacement (Without Sunroof) .
  3. Remove the windshield side garnish molding. Refer to Windshield Side Garnish Molding Replacement .
    4. Fig 1: Side Rail Module Security Clips And Fasteners
    GM2194138Courtesy of GENERAL MOTORS COMPANY
  4. Remove the 2 security clips (1), and remove the 5 fasteners (2).
    5. Fig 2: Wiring Harness Plug
    GM2194139Courtesy of GENERAL MOTORS COMPANY
  5. Release and disconnect the wiring harness plug (1).
  6. Unscrew the fastener from the inflatable restraint roof side rail module (2).
  7. Open the metal clip (3) and remove it.
    8. Fig 3: Inflatable Restraint Roof Side Rail Module
    GM2194140Courtesy of GENERAL MOTORS COMPANY
  8. Remove the inflatable restraint roof side rail module (1) from the vehicle.
scientia non olet · About Mike's Workshop Manuals