Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2012 >> Regal Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Fuel Injector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Rail Assembly Component View
    GM854298Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Always install new injector O-rings when servicing the fuel injectors. Lubricate the new injector O-rings with clean engine oil.
  1. Install the O-rings on the fuel injector (4, 7).
  2. Install the fuel injector clip (3) on the fuel injector (5).
    3. IMPORTANT: The fuel injector will click when the injector is installed correctly.
  3. Install the fuel injector in the fuel rail with the connector facing upward.
  4. Connect the fuel injector harness electrical connector(s) to the fuel injector(s).
  5. Install the fuel rail. Refer to Fuel Injection Fuel Rail Assembly Replacement .
scientia non olet · About Mike's Workshop Manuals