Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2011 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Lighting System) >> Diagnostic Information and Procedures >> DTC B2580 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Voltage is applied at all times to the headlamp high beam relay from battery voltage. When the multifunction switch is placed in either the FTP or HIGH position, ground is applied through the signal circuits to the body control module (BCM). The BCM then applies a ground to the headlamp high beam relay control circuit. This energizes the relay and applies voltage through the HI BEAM fuses to both left and right headlamp assemblies energizing the high beam solenoids.

scientia non olet · About Mike's Workshop Manuals