Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2009 >> Allure Super >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 3.8L - Introduction) >> Repair Instructions >> Ignition Coil Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the ignition coil (2).
    2. Fig 1: View Of Ignition Coil Module And Module Mounting Bracket
    GM12299Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the ignition coil screws (1).

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  3. Connect the spark plug wires.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) .
scientia non olet · About Mike's Workshop Manuals