Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2009 >> Allure Super >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 3.8L - Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (NU6) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying fuel tank wiring harness electrical connector
    GM1755107Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor (1).
  2. Connect the fuel tank wiring harness electrical connector (2) to the fuel tank pressure sensor.
  3. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals