Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2009 >> Allure Super >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 3.8L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the camshaft position sensor to the engine front cover.
    2. Fig 1: Disconnecting/Reconnecting Electrical Connector To CMP Sensor
    GM389047Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the camshaft position sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Connect the electrical connector (2) to the camshaft position sensor (1).
  4. Install the drive belt. Refer to Drive Belt Replacement (L26) .
  5. Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement (L26) .
scientia non olet · About Mike's Workshop Manuals