Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2009 >> Allure Super >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 3.8L - Introduction) >> Repair Instructions >> Barometric Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing MAP & BARO Sensors Retaining Clips
    GM1210599Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the barometric pressure (BARO) sensor electrical connector.
  3. Remove the BARO sensor retainer.
  4. Remove the BARO sensor.
scientia non olet · About Mike's Workshop Manuals