Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2009 >> Allure Super >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 3.8L - Introduction) >> Repair Instructions >> Barometric Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing MAP & BARO Sensors Retaining Clips
    GM1210599Courtesy of GENERAL MOTORS CORP.
  1. Install the BARO sensor.
  2. Install the BARO sensor retainer.
  3. Connect the BARO sensor electrical connector.
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About Mike's Workshop Manuals