Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 5.3L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Electrical Connectors
    GM1551867Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (2).
    3. Fig 2: View Of MAP Sensor
    GM1411911Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAP sensor (714) from the intake manifold.
  4. Remove the MAP sensor grommet (715), if required.
scientia non olet · About Mike's Workshop Manuals