Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2009 >> Allure CX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.8L - Introduction >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement (NU6) >> Removal Procedure

Removal Procedure

    Fig 1: Identifying fuel tank wiring harness electrical connector
    GM1755107Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the fuel tank wiring harness electrical connector (2) from the fuel tank pressure sensor.
  3. Remove the fuel tank pressure sensor (1).
scientia non olet · About Mike's Workshop Manuals