Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2007 >> Rendezvous CX >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular System, Entertainment System, And Navigation System >> Repair Instructions >> Radio Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Radio Electrical/Audio/Coaxial Electrical Connectors
    GM319670Courtesy of GENERAL MOTORS CORP.
  1. Connect the coaxial cable connector to the radio.
  2. Connect the electrical/audio connectors to the radio.
  3. Install the radio to the I/P.
    IMPORTANT: If the radio locator tab is difficult to align to the I/P locator opening, pull the radio toward you and reposition the antenna cable.

    Align the radio control locator tab to the I/P locator hole while carefully pressing the radio into the I/P until fully seated.

    4. Fig 2: Identifying Radio Screws
    GM319664Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the radio screws.

    Tighten:  Tighten the radio screws to 2.5 N.m (22 lb in).

  5. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  6. Perform the radio set-up procedure. Refer to Control Module References for programming and setup information.
scientia non olet · About Mike's Workshop Manuals