Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2007 >> Rendezvous CX >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular System, Entertainment System, And Navigation System >> Repair Instructions >> Digital Radio Receiver Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Radio Wiring Harness
    GM955738Courtesy of GENERAL MOTORS CORP.
  1. Install the XM digital radio receiver to the receiver bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the radio receiver nuts.

    Tighten:  Tighten the nuts to 4 N.m (35 lb in).

    3. Fig 2: Identifying XM Digital Radio Receiver
    GM955754Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector and the antenna connectors to the XM radio receiver.
  4. Install the I/P compartment. Refer to Instrument Panel Compartment Replacement .
  5. Perform the setup procedure for the digital radio receiver. Refer to Control Module References for programming and setup information.
scientia non olet · About Mike's Workshop Manuals