Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2007 >> Rainier 5.3 M, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Traction Control Switch Replacement (GMC, Chevrolet) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Isuzu Ascender, 2006 GMC Envoy XL, 2006 GMC Envoy, 2006 Chevrolet TrailBlazer, and 2006 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Traction Control Switch Electrical Connector
    GM651279Courtesy of GENERAL MOTORS CORP.
  1. Position the traction control switch to the trim plate
  2. Install the traction control switch to the instrument panel trim plate by seating the locking tabs.
  3. Connect the electrical connector to the traction control switch.
  4. Install the accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (GMC) or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Buick) or Bezel Replacement - Instrument Panel (I/P) Cluster (Chevrolet) or Bezel Replacement - Instrument Panel (I/P) Cluster (GMC, Buick) in Instrument Panel, Gages, and Console.
scientia non olet · About Mike's Workshop Manuals