Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2007 >> Rainier 5.3 M, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 5.3L - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement (Left Side) >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Knock Sensor, Engine Harness & Engine Block - Left Side
    GM1480894Courtesy of GENERAL MOTORS CORP.
  1. Reconnect the engine harness (3) and the knock sensor (2) electrical connectors.
  2. Position the knock sensor 2 on the engine block (4).
  3. Install the mounting bolt (1) for the knock sensor 2.
    4. NOTE: Refer to Fastener Notice .
  4. Tighten the knock sensor mounting bolt (1).

    Tighten:  Tighten the knock sensor mounting bolt to 20 N.m (15 lb ft).

scientia non olet · About Mike's Workshop Manuals