Installation Procedure

Position the battery positive cable to the engine.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

Fig 1: View Of Starter Terminal Nut & Battery Positive Cable

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Connect the battery positive cable (2) to the starter and install the starter terminal nut (1).
Tighten: Tighten the battery positive cable nut to 13 N.m (115 lb in).

Fig 2: View Of Battery Positive Lead & Generator BAT Terminal Nut

Courtesy of GENERAL MOTORS CORP.

Connect the battery positive lead (2) to the generator and install the generator BAT terminal nut (3).
Tighten: Tighten the generator BAT terminal nut to 13 N.m (115 lb in).
Install the protective boot to the generator output BAT terminal.
Lower the vehicle.

Fig 3: Identifying Battery Positive Cable To Underhood Fuse Block

Courtesy of GENERAL MOTORS CORP.

Install the nut (1) securing the battery positive cable (2) to the electrical center.
Tighten: Tighten the battery positive cable to electrical center nut to 15 N.m (11 lb ft).

Fig 4: View Of Underhood Fuse Box

Courtesy of GENERAL MOTORS CORP.

Fig 5: View Of Battery Positive & Negative Cables

Courtesy of GENERAL MOTORS CORP.

Connect the battery positive cable to the battery.
Tighten: Tighten the battery cable to 17 N.m (13 lb ft).
Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (3.8L) or Battery Negative Cable Disconnection and Connection (3.6L) .