Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2006 >> Allure CXS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Accelerator Pedal
    GM910941Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator pedal (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the accelerator pedal bolts (2).

    Tighten:  Tighten the bolts to 5 N.m (44 lb in).

  3. Connect APP sensor electrical connector.
  4. Install the left I/P sound insulator. Refer to Closeout/Insulator Panel Replacement - Left .
scientia non olet · About Mike's Workshop Manuals