Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Rendezvous Ultra, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.6L - Introduction >> Repair Instructions >> Barometric Pressure (BARO) Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Barometric Pressure (BARO) Sensor Electrical Connector
    GM1401472Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the sensor electrical connector.
    3. Fig 2: Locating Barometric Pressure (BARO) Sensor & Bolt
    GM1395942Courtesy of GENERAL MOTORS CORP.
  3. Remove the barometric pressure sensor bolt.
  4. Remove the barometric pressure sensor.
scientia non olet · About Mike's Workshop Manuals