Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Rendezvous Ultra, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.4L - Introduction) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Intake Air Temperature (IAT) Sensor Electrical Connector
    GM740106Courtesy of GENERAL MOTORS CORP.
  1. Install the IAT sensor (1) by snapping into place.
  2. Connect the IAT sensor electrical connector.
scientia non olet · About Mike's Workshop Manuals