Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Rendezvous Ultra, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 3.4L - Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Tank Pressure Sensor
    GM682671Courtesy of GENERAL MOTORS CORP.
  1. Install the new fuel tank pressure sensor (1) to the modular fuel sender.
  2. Connect the electrical connector to fuel tank vapor pressure sensor.
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About Mike's Workshop Manuals