Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Rendezvous Ultra, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.6L - Introduction >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
    GM1395972Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the mass air flow (MAF) electrical connector.
  3. Remove the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  4. Remove the MAF sensor screws.
  5. Remove the MAF sensor and the MAF sensor seal.
scientia non olet · About Mike's Workshop Manuals