Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Rendezvous Ultra, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.6L - Introduction >> Repair Instructions >> Hose, Fuel Feed - Replacement >> Installation Procedure

Installation Procedure

  1. Install the purge line retainer to the fuel feed hose bracket as necessary.
    2. Fig 1: Locating Fuel Feed Hose From The Fuel Rail
    GM1401465Courtesy of GENERAL MOTORS CORP.
  2. Install the fuel feed hose to the fuel rail.
    3. Fig 2: View Of Fuel Feed Hose Bracket Bolt
    GM1401470Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the fuel feed hose bracket and the fuel feed hose bracket bolt.

    Tighten:  Tighten the fuel feed hose bracket bolt to 10 N.m (89 lb in).

    4. Fig 3: Identifying Purge Line Retainer
    GM1401471Courtesy of GENERAL MOTORS CORP.
  4. Install the purge line to the purge line retainer.
  5. Install the fuel pressure and EVAP hoses to the engine. Refer to Quick Connect Fitting(s) Service (Metal Collar)  and Quick Connect Fitting(s) Service (Plastic Collar) .
  6. Install the air inlet duct. Refer to Air Cleaner Intake Duct Replacement .
scientia non olet · About Mike's Workshop Manuals