Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of VSS & O-Ring
    GM10711Courtesy of GENERAL MOTORS CORP.
  1. Inspect the O-ring (11). If damaged, replace as necessary.
    2. Fig 2: Identifying Vehicle Speed Sensor (VSS)
    GM10516Courtesy of GENERAL MOTORS CORP.
  2. Install the vehicle speed sensor (10) and the retaining bolt (9).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  3. Connect the electrical connector to the sensor.
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals