Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Oil Pressure Test Plug Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Line Pressure Pipe Plug
    GM164784Courtesy of GENERAL MOTORS CORP.
  1. Install the line pressure pipe plug (38).

    Tighten:  Tighten the line pressure pipe plug (38) to 12 N.m (106 lb in).

  2. Install the throttle body air inlet duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls.
scientia non olet · About Mike's Workshop Manuals