Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Century Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Controls 3.1L (Introduction, Service & Replacement)) >> Repair Instructions >> Mass Air Flow (MAF) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Air Cleaner Intake Duct Components
    GM811623Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF sensor to the air cleaner intake duct.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the air cleaner intake duct to the air cleaner housing (8) and the throttle body.

    Tighten:  Tighten the clamps (2, 6) to 2 N.m (18 lb in).

  3. Connect the MAF sensor electrical connector (5).
  4. Connect the IAT sensor electrical connector (3).
  5. Start and idle the engine.
  6. Inspect the air cleaner intake duct for leaks.
scientia non olet · About Mike's Workshop Manuals