Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Century Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Controls 3.1L (Introduction, Service & Replacement)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Air Cleaner Intake Duct Components
    GM811623Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the intake air temperature (IAT) sensor electrical connector (3).
  2. Carefully grasp the sensor and with a twisting and pulling motion, remove the IAT sensor (1) from air cleaner intake duct.
scientia non olet · About Mike's Workshop Manuals