Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Century Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Controls 3.1L (Introduction, Service & Replacement)) >> Repair Instructions >> Ignition Coil(s) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spark Plug Wire Connections To Ignition Coils
    GM15977Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil to the ignition control module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition coil screws.

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  3. Connect the spark plug wires.
scientia non olet · About Mike's Workshop Manuals