Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Century Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Controls 3.1L (Introduction, Service & Replacement)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CMP Sensor
    GM16120Courtesy of GENERAL MOTORS CORP.
  1. Remove the power steering pump. Refer to Power Steering Pump Replacement (3.1L) or Power Steering Pump Replacement (3.8L) in Power Steering Systems.
  2. Disconnect the camshaft position (CMP) sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
  5. Inspect the sensor O-ring for wear, cracks or leakage if the sensor is not being replaced.
scientia non olet · About Mike's Workshop Manuals