Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the CKP sensor.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    2. Fig 1: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  2. Install the CKP sensor retaining fastener.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector
    GM56592Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector.
    4. Fig 3: View Of Starter
    GM211621Courtesy of GENERAL MOTORS CORP.
  4. Install the starter. Refer to Starter Motor Replacement in Engine Electrical.
  5. Lower the vehicle.
  6. Connect the negative battery cable.
  7. Perform the CKP system variation learn procedure. Refer to CKP System Variation Learn Procedure .
scientia non olet · About Mike's Workshop Manuals