Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Allure CXS >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean the area around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.
    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement (6.0L (LQ4)) in Engine Mechanical 6.0L.
  2. Disconnect the CMP sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.
scientia non olet · About Mike's Workshop Manuals