Installation Procedure
WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the bulb into the socket.
- Turn the bulb socket clockwise in order to lock the socket into the lamp assembly.
- Install the lamp assembly to the vehicle.
- Connect the electrical connector.
- Ensure the foam gasket is in place and is note damaged. Replace the foam gasket, if damaged.
- Tilt the lamp forward to engage the hook.
- Apply light pressure downward on the lamp in order to engage the retention clip.
- Remove the 2 layers of masking tape.