Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Introduction) >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The embossed arrow on the MAF/IAT sensor indicates the proper air flow direction. The arrow must point toward the engine.
    Fig 1: MAF/IAT Sensor Air Flow Direction Arrow
    GM359112Courtesy of GENERAL MOTORS CORP.
  1. Locate the air flow direction arrow (2) on the MAF/IAT sensor.
    2. Fig 2: MAF/IAT Sensor & Air Cleaner Assembly
    GM832908Courtesy of GENERAL MOTORS CORP.
  2. Install the MAF/IAT sensor on to the air cleaner housing.
  3. Tighten the clamp securing the MAF/IAT sensor to the air cleaner housing.
  4. Connect the MAF/IAT electrical connector.
  5. Install air intake resonator. Refer to Air Cleaner Resonator Outlet Duct Replacement .
scientia non olet · About Mike's Workshop Manuals