Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Buick >> 2005 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Top Engine Cover
    GM665886Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement (6.0L (LQ4)) in Engine Mechanical.
  2. Remove the engine sight shield bracket bolts. Position the bracket to the side
  3. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
    4. Fig 2: View Of Manifold Absolute Pressure (MAP) Sensor
    GM863068Courtesy of GENERAL MOTORS CORP.
  4. Remove the MAP sensor (1) from the intake manifold.
scientia non olet · About Mike's Workshop Manuals